YODAONE
May 21, 2017
Bottom half of intake manifold after extrude honing...very polished...impossible to do with conventional porting...the goal here was never to port, but simply to remove all the casting flash to increase intake charge velocity and decrease heat radiation into intake stream (smooth surface over rough casting has less surface are)
Original Thread
1998-2000 ls400 (2001-2006 ls430) intake manifold extrude honeMore About This Picture
Vehicle
N/A
Location
N/A
Keywords
N/A
Discover More Pictures
See MoreAdvertisement
Be the first to comment on this picture!